Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

dthom0425
  • Locked
  • Question Question
Arc as a datum?
Replies
11
Views
562
Tarator
Tarator
Rwelch9
  • Locked
  • Question Question
True position applied to planes
2 3
Replies
51
Views
2K
Burunduk
Burunduk
Andera
  • Locked
  • Question Question
ISO translation
Replies
4
Views
408
pmarc
pmarc
Jacob Cheverie
  • Locked
  • Question Question
Position tolerance on an assembly
Replies
8
Views
493
drawoh
drawoh
Belanger
  • Locked
  • Question Question
Position for noncircular FOS at MMC
Replies
8
Views
179
Belanger
Belanger
Sa-Ro
  • Locked
  • Question Question
Datum shift with two feature
Replies
5
Views
260
Sa-Ro
Sa-Ro
drawoh
  • Locked
  • Question Question
Sloppy Tolerances
Replies
13
Views
293
chez311
chez311
ScottishRasta
  • Locked
  • Helpful tip Helpful tip
FULL R vs R --- It's origins and how to use it properly
Replies
3
Views
2K
drawoh
drawoh
cr7
  • Locked
  • Question Question
Perp vs. TP - mini quiz - ISO
Replies
5
Views
161
pmarc
pmarc
Sa-Ro
  • Locked
  • Question Question
+/- Tolerance vs GD&T
2 3
Replies
55
Views
843
Sa-Ro
Sa-Ro
Siva Mareesan
  • Locked
  • Question Question
Two questions regarding Pitch Circle Diameter in Gear
Replies
9
Views
1K
mfgenggear
mfgenggear
SeasonLee
  • Locked
  • Question Question
Is it valid on the profile tolerance callout?
Replies
13
Views
496
SeasonLee
SeasonLee
Rwelch9
  • Locked
  • Question Question
Drawing error ?
2
Replies
31
Views
1K
Burunduk
Burunduk
Buck61
  • Locked
  • Question Question
I'm working on a tolerance stack an
Replies
4
Views
520
Tarator
Tarator
Belanger
  • Locked
  • Question Question
Degrees of freedom for an orientation control
Replies
8
Views
649
greenimi
greenimi
DRWCA
  • Locked
  • Question Question
Unilateral Profile Tolerance with Bonus
2 3
Replies
44
Views
982
axym
axym
SeasonLee
  • Locked
  • Question Question
MMB size gage pin
Replies
7
Views
274
greenimi
greenimi
philyherb1
  • Locked
  • Question Question
Should Number of Digits of Hole Size Match Feature Control Frame Tolerance number of digits?
Replies
11
Views
837
drawoh
drawoh
Burunduk
  • Locked
  • Question Question
The means to break a simultaneous requirement within a pattern
Replies
19
Views
598
Burunduk
Burunduk
Kedu
  • Locked
  • Question Question
Maximum possible flatness error ISO versus ASME
Replies
19
Views
890
greenimi
greenimi
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top