Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

AMontembeault
  • Locked
  • Question Question
Profile without Datum reference
Replies
3
Views
309
chez311
chez311
dthom0425
  • Locked
  • Question Question
Inspection with Pattern of Holes
Replies
1
Views
477
Belanger
Belanger
banshee1
  • Locked
  • Question Question
GD&T question
Replies
13
Views
457
banshee1
banshee1
SeasonLee
  • Locked
  • Question Question
A typo on Fig. B-14 ?
Replies
7
Views
196
ctopher
ctopher
SeasonLee
  • Locked
  • Question Question
MMB at FCF on gage design
Replies
12
Views
685
chez311
chez311
PaulieUMF
  • Locked
  • Question Question
thread class question...
Replies
2
Views
294
chez311
chez311
Jan-Work
  • Locked
  • Question Question
Symmetry lines / Center lines
Replies
0
Views
146
Jan-Work
Jan-Work
Bill B.
  • Locked
  • Question Question
application of total run-out
2
Replies
33
Views
1K
chez311
chez311
Jacob Cheverie
  • Locked
  • Question Question
Straightness tolerance - Effect on material boundary size
2
Replies
21
Views
594
Belanger
Belanger
dthom0425
  • Locked
  • Question Question
Project Tol Zone Rule of Thumb?
Replies
4
Views
358
drawoh
drawoh
Michael Boble
  • Locked
  • Question Question
TOLERANCE STAK UP
Replies
3
Views
535
pmarc
pmarc
Perka
  • Locked
  • Question Question
What's the diameter? Indirect dimensioned with offset from a circular feature with g6 tolerance
Replies
5
Views
188
Tmoose
Tmoose
SeasonLee
  • Locked
  • Question Question
Translation modifier question
Replies
17
Views
624
3DDave
3DDave
gabimo
  • Locked
  • Question Question
Profile control and size
Replies
11
Views
476
3DDave
3DDave
Rwelch9
  • Locked
  • Question Question
Simultaneous requirements
Replies
5
Views
929
axym
axym
David R
  • Locked
  • Question Question
Difference between IT6 and H6 when applying to parts?
Replies
4
Views
559
juergenwt
juergenwt
SeasonLee
  • Locked
  • Question Question
Datum feature and its setup
Replies
18
Views
934
axym
axym
Jacob Cheverie
  • Locked
  • Question Question
GD&T Theory - Position/Translation Modifier
Replies
11
Views
316
Dean Watts
Dean Watts
Rwelch9
  • Locked
  • Question Question
Coaxial Pockets
Replies
4
Views
134
Rwelch9
Rwelch9
Siva Mareesan
  • Locked
  • Question Question
Need balloon if there is only one item in BOM table?
Replies
12
Views
864
Siva Mareesan
Siva Mareesan
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top