Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

ashivu123
  • Locked
  • Question
UNTOLERANCED DIMENSIONS ARE BASIC note in drawing 2
2
Replies
29
Views
2K
CheckerHater
CheckerHater
jgabrasives
  • Locked
  • Question
Equal distance dimensions 1
Replies
6
Views
810
mkcski
mkcski
Nescius
  • Locked
  • Question
Odd All-Around Profile Application
2
Replies
29
Views
736
Nescius
Nescius
loka23
  • Locked
  • Question
Tolerance stack up analysis for Dia 11.20H8 hole
Replies
2
Views
87
mkcski
mkcski
duk748
  • Locked
  • Question
+/- ,13mm (.005") on length tolerance not possible
Replies
9
Views
191
1gibson
1gibson
dho
  • Locked
  • Question
position tolerance
Replies
13
Views
366
dho
dho
cmmguy75
  • Locked
  • Question
Slot called out for True Position and Full Radius at 2 end. 1
Replies
5
Views
309
Belanger
Belanger
mkcski
  • Locked
  • Question
Locating scribe-lines with GDT
Replies
9
Views
508
KENAT
KENAT
dho
  • Locked
  • Question
position tolerance
2
Replies
27
Views
572
powerhound
powerhound
Triniprince
  • Locked
  • Question
Dimensioning Lofts and splines in a 2D drawing 4
Replies
10
Views
362
Triniprince
Triniprince
Nescius
  • Locked
  • Question
Seemingly incomplete tolerancing, reality check needed
Replies
15
Views
270
Nescius
Nescius
drstrole
  • Locked
  • Question
Conical Datum Features
Replies
2
Views
181
greenimi
greenimi
Madhu454
  • Locked
  • Question
Min Wall Thickness - GD&T v/s Note 2
Replies
16
Views
421
greenimi
greenimi
loka23
  • Locked
  • Question
free or constrained state
Replies
3
Views
218
drawoh
drawoh
dtmbiz
  • Locked
  • Question
Self-Referencing datums; all around profile (REF: GDT Question thread) 4
Replies
8
Views
639
pmarc
pmarc
XaeroR35
  • Locked
  • Question
Datum Tolerance using sheet stock 1
Replies
4
Views
231
ewh
ewh
hobbs101
  • Locked
  • Question
hole thru into section - correct drawing note?
Replies
11
Views
907
JNieman
JNieman
randy64
  • Locked
  • Question
Can a feature be called Concentric to a Datum that is established by a Bolt Circle?
Replies
10
Views
526
pylfrm
pylfrm
BalajiPG
  • Locked
  • Question
Measurement of Basic Dimension
Replies
2
Views
125
3DDave
3DDave
lwh723
  • Locked
  • Question
GD&T question 5
2 3
Replies
45
Views
837
axym
axym
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom