Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

Gerres
  • Locked
  • Question Question
Gd&t and model based (MBD) drawing
Replies
2
Views
144
iamerror
iamerror
cervantes
  • Locked
  • Question Question
axis datum - bearing
Replies
7
Views
377
Tmoose
Tmoose
Vindicit
  • Locked
  • Question Question
Datum Question with True Position
Replies
14
Views
644
ashivu123
ashivu123
cinnamongirl
  • Locked
  • Question Question
Dimensioning standard for sheet metal part
Replies
14
Views
1K
SeasonLee
SeasonLee
MCich
  • Locked
  • Question Question
ANSI sprocket profile vs ISO sprocket profile dimesnioning
Replies
2
Views
299
MCich
MCich
Spoonful
  • Locked
  • Question Question
UNO or UON
Replies
8
Views
2K
CheckerHater
CheckerHater
UGMENTALCASE
  • Locked
  • Question Question
COMMON ZONE MODIFIER - DO I NEED IT?
Replies
2
Views
365
UGMENTALCASE
UGMENTALCASE
pdiletti
  • Locked
  • Question Question
DIN 16742 for Plastic parts
Replies
0
Views
203
pdiletti
pdiletti
gabimo
  • Locked
  • Question Question
QC inspector - pre-qual job test question
2 3
Replies
59
Views
596
mkcski
mkcski
shivaaraam
  • Locked
  • Question Question
drawing design difference
Replies
6
Views
347
dgallup
dgallup
rsm7400
  • Locked
  • Question Question
Flatness Callout Question
Replies
10
Views
286
rsm7400
rsm7400
3DDave
  • Locked
  • Question Question
The Gauge Block Handbook
Replies
0
Views
48
3DDave
3DDave
RichardStarrbuck
  • Locked
  • Question Question
ANGLES: "2X" or "2 PLACES"
Replies
9
Views
958
3DDave
3DDave
UchidaDS
  • Locked
  • Question Question
Dimension Inspection
Replies
10
Views
770
Belanger
Belanger
rhmeng
  • Locked
  • Question Question
Parent view for section view off of drawing
Replies
17
Views
1K
ewh
ewh
RichardStarrbuck
  • Locked
  • Question Question
Dimensioning Folded Sheet Metal
Replies
4
Views
979
berkshire
berkshire
ashivu123
  • Locked
  • Question Question
GD&T for Holes are in Angular face
Replies
5
Views
339
3DDave
3DDave
IntolerantofApathy
  • Locked
  • Question Question
Polar Equivalent to Ordinate Dimensioning in Conjunction with 14.5?
Replies
4
Views
391
CheckerHater
CheckerHater
rhmeng
  • Locked
  • Question Question
GD&T Basics and True Position Conversion Charts
Replies
9
Views
580
mkcski
mkcski
AMontembeault
  • Locked
  • Question Question
Fastener/Hardware Specifications - ISO
Replies
2
Views
241
Tunalover
Tunalover
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top