Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

dho
  • Locked
  • Question Question
position tolerance
Replies
13
Views
837
dho
dho
cmmguy75
  • Locked
  • Question Question
Slot called out for True Position and Full Radius at 2 end.
Replies
5
Views
398
Belanger
Belanger
mkcski
  • Locked
  • Question Question
Locating scribe-lines with GDT
Replies
9
Views
705
KENAT
KENAT
dho
  • Locked
  • Question Question
position tolerance
2
Replies
27
Views
2K
powerhound
powerhound
Triniprince
  • Locked
  • Question Question
Dimensioning Lofts and splines in a 2D drawing
Replies
10
Views
444
Triniprince
Triniprince
Nescius
  • Locked
  • Question Question
Seemingly incomplete tolerancing, reality check needed
Replies
15
Views
413
Nescius
Nescius
drstrole
  • Locked
  • Question Question
Conical Datum Features
Replies
2
Views
221
greenimi
greenimi
Madhu454
  • Locked
  • Question Question
Min Wall Thickness - GD&T v/s Note
Replies
16
Views
587
greenimi
greenimi
loka23
  • Locked
  • Question Question
free or constrained state
Replies
3
Views
247
drawoh
drawoh
dtmbiz
  • Locked
  • Question Question
Self-Referencing datums; all around profile (REF: GDT Question thread)
Replies
8
Views
847
pmarc
pmarc
XaeroR35
  • Locked
  • Question Question
Datum Tolerance using sheet stock
Replies
4
Views
277
ewh
ewh
hobbs101
  • Locked
  • Question Question
hole thru into section - correct drawing note?
Replies
11
Views
1K
JNieman
JNieman
randy64
  • Locked
  • Question Question
Can a feature be called Concentric to a Datum that is established by a Bolt Circle?
Replies
10
Views
684
pylfrm
pylfrm
BalajiPG
  • Locked
  • Question Question
Measurement of Basic Dimension
Replies
2
Views
140
3DDave
3DDave
lwh723
  • Locked
  • Question Question
GD&T question
2 3
Replies
45
Views
1K
axym
axym
SaberRaide
  • Locked
  • Question Question
MS Spec listed in title block
Replies
1
Views
107
KENAT
KENAT
venomex
  • Locked
  • Question Question
new standard for 'roh'
Replies
4
Views
435
venomex
venomex
cervantes
  • Locked
  • Question Question
roughness symbol for raw surface
Replies
7
Views
793
CheckerHater
CheckerHater
UGMENTALCASE
  • Locked
  • Question Question
Tolerance a profile to become a fit
Replies
6
Views
184
CheckerHater
CheckerHater
pdiletti
  • Locked
  • Question Question
Sections and views naming
Replies
8
Views
2K
dgallup
dgallup
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top