Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

ashivu123
  • Locked
  • Question Question
MMC (M Symbol) for datum in FCF
Replies
8
Views
527
Belanger
Belanger
LCform
  • Locked
  • Question Question
I need some advices on Engineering Document Management
Replies
1
Views
121
KENAT
KENAT
cervantes
  • Locked
  • Question Question
free state
2
Replies
36
Views
958
pylfrm
pylfrm
gabimo
  • Locked
  • Question Question
Buna N O-ring measurements
Replies
15
Views
213
dgallup
dgallup
Spurs
  • Locked
  • Question Question
asking for help on how to define G,D &T for this part
Replies
9
Views
252
pylfrm
pylfrm
ModulusCT
  • Locked
  • Question Question
Reality Check on TP for Embossement Keys
Replies
10
Views
272
ModulusCT
ModulusCT
Nescius
  • Locked
  • Question Question
Rules for composite profile, datums in lower segment
Replies
2
Views
551
Nescius
Nescius
tanner78
  • Locked
  • Question Question
Position tolerance of an axis?
Replies
5
Views
367
KENAT
KENAT
LCform
  • Locked
  • Question Question
How much would be differenct between these two types of tolerating ?
Replies
6
Views
109
SwinnyGG
SwinnyGG
TWJR
  • Locked
  • Question Question
gd&t on weldments
Replies
4
Views
594
ewh
ewh
kahlju
  • Locked
  • Question Question
General Tolerances: Where do you datum from? Please help
2
Replies
26
Views
1K
CheckerHater
CheckerHater
AMontembeault
  • Locked
  • Question Question
Application of Scale
Replies
8
Views
713
KENAT
KENAT
Evom
  • Locked
  • Question Question
ISO envelope applications
Replies
13
Views
722
CheckerHater
CheckerHater
ntrb28
  • Locked
  • Question Question
ASME Y14.5 - Flag Note Requirements
Replies
1
Views
557
KENAT
KENAT
James7443
  • Locked
  • Question Question
Single document containing p/n with and without dash numbers.
Replies
9
Views
449
jassco
jassco
ModulusCT
  • Locked
  • Question Question
Two Cylinders as Datum Features for True Position
Replies
6
Views
781
ModulusCT
ModulusCT
pateli04
  • Locked
  • Question Question
ASME Y14.41-2012 - Nominal Dimensioning Value
Replies
14
Views
868
pateli04
pateli04
TheWizardofWoz
  • Locked
  • Question Question
Deleting a "Flag Note"
Replies
3
Views
429
ctopher
ctopher
artnmotion
  • Locked
  • Question Question
Rockwell Hardness Callout
Replies
4
Views
1K
Gilmiril
Gilmiril
Evom
  • Locked
  • Question Question
Positional tolerance: bi-direction
Replies
6
Views
749
CheckerHater
CheckerHater
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top