I am having a problem getting an offset xsection to display correctly in a drawing. Sometimes all I see is the xhatching, other times the xsection fails when I try to use it in a drawing view. It seems to work if I'm careful not to sketch the xsection on a centerline. This is an assembly in version 2001. One thing I noticed is that the parts in this assembly were created without symmetry constraints, could that be part of the problem?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
OFFSET XSECTION DISPLAY
- Thread starter conanzx
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question