Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

No stress output in restart analysis

Status
Not open for further replies.

bridgehl

Civil/Environmental
Joined
Dec 23, 2006
Messages
35
Location
JP
I am doing a transient contact problem. Because my problem takes a long time to finish, I set up parameters for a multiframe restart.

When Ansys runs throughout to the end, the result output is correct as what I set in OUTRES parameters. However, when I restart the analysis, I can get all the results I want except nodal stresses. All of the stress is zero from the restarting time although the OUTRES parameters are the same.

Could anyone help me please! Thank you.

Bridge
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top