bridgehl
Civil/Environmental
- Dec 23, 2006
- 35
I am doing a transient contact problem. Because my problem takes a long time to finish, I set up parameters for a multiframe restart.
When Ansys runs throughout to the end, the result output is correct as what I set in OUTRES parameters. However, when I restart the analysis, I can get all the results I want except nodal stresses. All of the stress is zero from the restarting time although the OUTRES parameters are the same.
Could anyone help me please! Thank you.
Bridge
When Ansys runs throughout to the end, the result output is correct as what I set in OUTRES parameters. However, when I restart the analysis, I can get all the results I want except nodal stresses. All of the stress is zero from the restarting time although the OUTRES parameters are the same.
Could anyone help me please! Thank you.
Bridge