Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

RobLN
  • Locked
  • Question Question
Section view cut lines in orange
Replies
2
Views
115
drawoh
drawoh
semiond
  • Locked
  • Question Question
Datum target cylinders?
2 3
Replies
40
Views
4K
Kedu
Kedu
semiond
  • Locked
  • Question Question
Difference between axial total runout and perpendicularity
2
Replies
34
Views
4K
chez311
chez311
ninjaz
  • Locked
  • Question Question
Is it acceptable if I create a datum feature and do not refer it anywhere in the drawing?
Replies
10
Views
2K
ninjaz
ninjaz
semiond
  • Locked
  • Question Question
Simulating a datum center plane
6 7 8
Replies
143
Views
3K
semiond
semiond
James Orlando
  • Locked
  • Question Question
Profile of a Surface
2 3
Replies
41
Views
2K
semiond
semiond
lonsgsp
  • Locked
  • Question Question
gdt question on use of a word in feature control frame
Replies
4
Views
252
lonsgsp
lonsgsp
bear9298
  • Locked
  • Question Question
Tangent line in a dimensional drawing
Replies
7
Views
827
TWJR
TWJR
Kedu
  • Locked
  • Question Question
ISO Simultaneous requirement 1998 vs 2016
2
Replies
21
Views
959
pmarc
pmarc
marvalgames
  • Locked
  • Question Question
Datum MMC as bonus. Newbie Alert
2
Replies
27
Views
2K
semiond
semiond
Phat Ph
  • Locked
  • Question Question
Trying to use GD&T on hole patterns - need advice
Replies
5
Views
659
chez311
chez311
jasoncwells
  • Locked
  • Question Question
Sheet Metal Joggles
Replies
1
Views
537
MikeHalloran
MikeHalloran
R1chJC
  • Locked
  • Question Question
Multiple Patterns of Features
Replies
9
Views
954
axym
axym
plowe68
  • Locked
  • Question Question
Bill of Materials
Replies
15
Views
678
drawoh
drawoh
R1chJC
  • Locked
  • Question Question
Another Angled Hole Positional Tolerance Question
2 3
Replies
46
Views
3K
chez311
chez311
ajcraig99
  • Locked
  • Question Question
Correct English in quantity note?
Replies
8
Views
327
dgallup
dgallup
Cyb_N
  • Locked
  • Question Question
How to Fold an Engineering Drawing
Replies
11
Views
2K
handleman
handleman
vanquang
  • Locked
  • Question Question
Effect of datum precedence
Replies
11
Views
738
greenimi
greenimi
jeballes
  • Locked
  • Question Question
Composite Position Tolerance Simultaneous Patterns
2
Replies
29
Views
1K
chez311
chez311
tharding247365
  • Locked
  • Question Question
Diametrical Position on a Square or Rectangular hole
Replies
15
Views
1K
CheckerHater
CheckerHater
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top