Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

KENAT
  • Locked
  • Question Question
Leader to minor or major dia on threaded features?
Replies
6
Views
158
CheckerHater
CheckerHater
bw009
  • Locked
  • Question Question
Simple dimensions
Replies
6
Views
185
drawoh
drawoh
CharlesHeard
  • Locked
  • Question Question
P&ID Symbol for ClearWELL
Replies
0
Views
87
CharlesHeard
CharlesHeard
Vimalmechs
  • Locked
  • Question Question
Doubt on Datum Callout
Replies
13
Views
253
pmarc
pmarc
Belanger
  • Locked
  • Question Question
Simiultaneous requirements
Replies
9
Views
270
Belanger
Belanger
bxbzq
  • Locked
  • Question Question
Do you use B4.2 a lot?
Replies
8
Views
365
CheckerHater
CheckerHater
dreber
  • Locked
  • Question Question
Text Height in Paper Space
Replies
1
Views
115
pmarc
pmarc
jeff97070
  • Locked
  • Question Question
Typical opposite end callout
Replies
11
Views
435
saf12
saf12
jimbod20
  • Locked
  • Question Question
Casting Definition and Inspsection
Replies
1
Views
200
pmarc
pmarc
greenimi
  • Locked
  • Question Question
Profile (for a radius defined with ¦) used to control location, can also control the size?
2
Replies
22
Views
526
pmarc
pmarc
MakingSense
  • Locked
  • Question Question
Describing special threads
Replies
2
Views
113
MakingSense
MakingSense
shaun8567
  • Locked
  • Question Question
Datums Required for Hole Position
2
Replies
20
Views
2K
pmarc
pmarc
DATS
  • Locked
  • Question Question
All around weld for cylindrical objects
Replies
4
Views
364
DATS
DATS
Madhu454
  • Locked
  • Question Question
Dimensioning continuous extruded parts ?
Replies
0
Views
80
Madhu454
Madhu454
Tenkan
  • Locked
  • Question Question
ANSI vs. ASME y14......
Replies
4
Views
1K
fcsuper
fcsuper
concerta
  • Locked
  • Question Question
"unit basis" for profile of a line
2
Replies
26
Views
1K
pmarc
pmarc
Rhyder88
  • Locked
  • Question Question
"Flatness area" annotation around a mounting hole - necessary if the plane is already flat
Replies
4
Views
229
Belanger
Belanger
ewh
  • Locked
  • Question Question
General Dimensioning Question
Replies
11
Views
255
Tenkan
Tenkan
bxbzq
  • Locked
  • Question Question
datum features for casting
2
Replies
28
Views
549
bxbzq
bxbzq
tactical14
  • Locked
  • Question Question
runout vs concentricity question
2
Replies
25
Views
847
TheTick
TheTick
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top