Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

bradacc
  • Locked
  • Question
Profile of a Surface Question
Replies
15
Views
329
powerhound
powerhound
Tenkan
  • Locked
  • Question
implied positional tolerance? 1
Replies
14
Views
573
pmarc
pmarc
frusso110
  • Locked
  • Question
Flatness of a Vibration Plate
Replies
3
Views
224
pmarc
pmarc
SpaciouS
  • Locked
  • Question
Feature of Size (FOS) 2
Replies
3
Views
152
SpaciouS
SpaciouS
ImnotfromMars
  • Locked
  • Question
Radius as a datum 3
2 3
Replies
42
Views
2K
Belanger
Belanger
fogleghorn
  • Locked
  • Question
Who implements ECO changes on engineering drawings? 2
Replies
12
Views
200
fogleghorn
fogleghorn
cjohnso0
  • Locked
  • Question
Obscure Perpendicularity Callout Help
Replies
5
Views
167
CheckerHater
CheckerHater
SpaciouS
  • Locked
  • Question
Overiding Rule #1 3
Replies
10
Views
643
SpaciouS
SpaciouS
oonker
  • Locked
  • Question
How to determine hole tolerance 1
Replies
9
Views
316
drawoh
drawoh
ronj100
  • Locked
  • Question
refine orientation of an angle with an orientation call out or composite the location?
2
Replies
27
Views
298
fsincox
fsincox
greenimi
  • Locked
  • Question
Primary datum A or B-C (primary)
2
Replies
32
Views
980
pmarc
pmarc
mdambros
  • Locked
  • Question
Special Metric Screw Threads
Replies
15
Views
745
juergenwt
juergenwt
JJAV1983
  • Locked
  • Question
CIRCULAR / TOTAL RUNOUT EFFECT ON DIAMETER-SIZE
Replies
15
Views
1K
Belanger
Belanger
fogleghorn
  • Locked
  • Question
Assembly Drawings consisting of a Bill of Materials only 1
2
Replies
25
Views
384
kjoiner
kjoiner
tmoxam
  • Locked
  • Question
What is the main advantage of having a separate document for the BOM 1
Replies
6
Views
350
CheckerHater
CheckerHater
ronj100
  • Locked
  • Question
Can profile be used without basic dimesions, but to establish orientation from datums?
Replies
8
Views
559
CheckerHater
CheckerHater
DiegoLGraves
  • Locked
  • Question
Title block tolerance for Fabrication 1
Replies
4
Views
190
drawoh
drawoh
SpaciouS
  • Locked
  • Question
Sequence in Referencing Datums 3
Replies
15
Views
422
pmarc
pmarc
jjbiot
  • Locked
  • Question
bore diameter in a 1/4-36 UNS-2A thread
Replies
12
Views
639
nobog
nobog
SeasonLee
  • Locked
  • Question
Perpendicularity axis to axis
Replies
4
Views
92
fsincox
fsincox
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom