Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

4Ed
  • Locked
  • Question Question
geometric tolerance value
Replies
5
Views
260
4Ed
4Ed
Keith1029
  • Locked
  • Question Question
Direct Tolerancing Interpretation
Replies
8
Views
248
Keith1029
Keith1029
Vimalmechs
  • Locked
  • Question Question
Doubt on datum
Replies
8
Views
168
Vimalmechs
Vimalmechs
jckc779
  • Locked
  • Question Question
ISO 2768 Postion Tolerance Question
Replies
7
Views
755
jckc779
jckc779
ronj100
  • Locked
  • Question Question
Does position tolerace apply at maximum hole size in MMC?
Replies
2
Views
142
ronj100
ronj100
jkate
  • Locked
  • Question Question
Pressure Vessel Drafting
Replies
0
Views
206
jkate
jkate
fsincox
  • Locked
  • Question Question
Simultaneous Requirement, does it apply to single holes and patterns?
Replies
3
Views
199
SeasonLee
SeasonLee
axym
  • Locked
  • Question Question
How to Annotate Holes Passing Through One Surface of a Part
2
Replies
24
Views
4K
pmarc
pmarc
Belanger
  • Locked
  • Question Question
Abbreviation TDL?
Replies
10
Views
620
Belanger
Belanger
pmarc
  • Locked
  • Question Question
Shortcomings of ASME Y14.5-2009?
Replies
17
Views
528
fsincox
fsincox
Saladsamurai
  • Locked
  • Question Question
Datum Target Lines: Not sure what this means
Replies
5
Views
329
DaSalo
DaSalo
jdg1111
  • Locked
  • Question Question
Chamfer call out on a threaded hole, where is it measured from?
Replies
13
Views
1K
KENAT
KENAT
htjames
  • Locked
  • Question Question
GD&T - Concentric circles
Replies
5
Views
455
powerhound
powerhound
SpaciouS
  • Locked
  • Question Question
ISO Standards Not Recodnizing Rule #1
2
Replies
27
Views
1K
dingy2
dingy2
Tenkan
  • Locked
  • Question Question
Clocking cylindrical parts with datum feature
Replies
15
Views
694
powerhound
powerhound
SpecialtyMFG
  • Locked
  • Question Question
True position
2
Replies
26
Views
650
fsincox
fsincox
Tenkan
  • Locked
  • Question Question
material condition modifiers on datum reference frames
Replies
4
Views
237
Tenkan
Tenkan
Tenkan
  • Locked
  • Question Question
Coaxial Datum features and their relationship...
2
Replies
20
Views
812
fsincox
fsincox
randy64
  • Locked
  • Question Question
Threaded Hole as a Datum Feature
Replies
12
Views
2K
SeasonLee
SeasonLee
Tenkan
  • Locked
  • Question Question
stock material roughness override...
Replies
10
Views
358
Tenkan
Tenkan
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top