Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

marshell
  • Locked
  • Question
ASME Y14.6 Thread Call out
Replies
5
Views
876
CheckerHater
CheckerHater
var10
  • Locked
  • Question
Manufacturing drawings have different part and drawing number! 1
Replies
12
Views
285
KENAT
KENAT
BEC1I
  • Locked
  • Question
Engineering Drawing
Replies
2
Views
85
dgallup
dgallup
sasi2707
  • Locked
  • Question
MMC for a basic dimension!
Replies
7
Views
144
Belanger
Belanger
greenimi
  • Locked
  • Question
Form/size control and all around profile
Replies
5
Views
93
greenimi
greenimi
xcllyf
  • Locked
  • Question
Concept of Zero Line,Fundamental deviation & GD&T Notes 1
Replies
3
Views
434
pmarc
pmarc
swoop360
  • Locked
  • Question
Circularity Tolerance--Controlling Ovality, Lobing and Irregularities Independently
Replies
3
Views
247
drawoh
drawoh
joshuabass
  • Locked
  • Question
Hole Pattern Tolerance Analysis 1
Replies
8
Views
1K
pmarc
pmarc
midnightblue
  • Locked
  • Question
minus-minus tolerance 1
Replies
8
Views
236
juergenwt
juergenwt
gregfox
  • Locked
  • Question
Datums BC Sometimes A
Replies
7
Views
252
gregfox
gregfox
frusso110
  • Locked
  • Question
Drawings for Manufacturing 1
Replies
7
Views
101
MikeHalloran
MikeHalloran
supergee
  • Locked
  • Question
ASME Y14.5.1M : Stabilization process for dummies. 1
Replies
3
Views
175
supergee
supergee
gregfox
  • Locked
  • Question
Circularity of Holes
Replies
4
Views
315
powerhound
powerhound
EcoMan
  • Locked
  • Question
L x W x H units 1
Replies
15
Views
355
ewh
ewh
ittuser01
  • Locked
  • Question
GD&T for 2 keyways on an impeller for a pump.
Replies
4
Views
188
greenimi
greenimi
jeff97070
  • Locked
  • Question
Parallelism used in an assembly between two parts 5
2 3
Replies
40
Views
1K
drawoh
drawoh
illini8181
  • Locked
  • Question
Should this dimension be boxed? 2
Replies
5
Views
295
illini8181
illini8181
learningchecker
  • Locked
  • Question
WHAT'S THE BEST GD&T CONTROL TO USE?
Replies
6
Views
107
learningchecker
learningchecker
Tenkan
  • Locked
  • Question
diametrical perpendicular tolerance zone...?
Replies
7
Views
461
CheckerHater
CheckerHater
Eins73
  • Locked
  • Question
Dimensioning Interpretation
Replies
10
Views
473
dgallup
dgallup
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom