Inside turning cutting force calculation
Inside turning cutting force calculation
(OP)
Hello Guys,
As you may know, cutting forces on machining forces depend on many parameters (workpiece material and geometry,tool geometry,cuuter,cutting regimes,cuttin Dynamics variables,process interaction),maybe more than 20 factors influencing it and varying in time.
I searched a lot,read many publications and I concluded that theoritical empirical models does not verifying with experiments and best one is to experiment.
Since there are many variables,it takes too much time and money to make experiments for very different conditions.
So,for final move,I wanted to ask you that What should I do make to get these cutting forces and frequency ranges?
Thank you for your kind answers
As you may know, cutting forces on machining forces depend on many parameters (workpiece material and geometry,tool geometry,cuuter,cutting regimes,cuttin Dynamics variables,process interaction),maybe more than 20 factors influencing it and varying in time.
I searched a lot,read many publications and I concluded that theoritical empirical models does not verifying with experiments and best one is to experiment.
Since there are many variables,it takes too much time and money to make experiments for very different conditions.
So,for final move,I wanted to ask you that What should I do make to get these cutting forces and frequency ranges?
Thank you for your kind answers
Talk To Other Members