Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Trying to make threads on a bolt or pipe in Autcad 3D

Status
Not open for further replies.
Jeffnm

Jeffnm

Mechanical
Joined
Jan 20, 2006
Messages
1
Location
US
How can I make threads on a bolt in autcad. I know how to make 3D objects but can't figure out how to make threads. I don't think it is possible to draw on the Z axis so I am at a loss. Thank -You
 
Sort by date Sort by votes
Threads are a royal pain. Search this forum. I don't think anyone has a good viable solution.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CAD2015
  • Locked
  • Question Question
Import a part in a selected view.....
Replies
10
Views
5K
CAD2015
CAD2015
G
  • Question Question
Question about mask on Draftsight
Replies
0
Views
1K
gpaiva
G
CAD2015
  • Question Question
Dimension tangent snap point on geometry ............................
Replies
4
Views
6K
Sparweb
Sparweb
Scrappydoo
  • Locked
  • Question Question
Convert a .dwg or pdf file into a .gp4
Replies
2
Views
1K
Scrappydoo
Scrappydoo
CAD2015
  • Locked
  • Question Question
AutoCAD file conversion from inch to mm.........................
Replies
15
Views
12K
dik
dik

Part and Inventory Search

Sponsor

Back
Top