Tolerance Mode greyed out on drawing

[warmwinds]

Tolerance Mode is greyed out in the Modify Dimension dialog box.

I have set the drawing setup option "tol_display" to "yes" in conig.proandthis allowed for tolerances to be shown when editting dimensions on the part model but this field is still greyed out in the drawing mode.

 

[charleskim]

Is it a driving dimension or created dimension.


If it is created dimension, you can't add tolerance.

 

[warmwinds]

It is a driven dimension. I fixed my problem by setting the "tol_display" to "yes" in both the config.pro and the configuration.dtl file.