Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creo drawing dimension arrows

Status
Not open for further replies.

Picklefactory

Automotive
Jun 4, 2008
29
Good morning all
I've lost my formatting somehow, I'll back track on that later when I have time and find my back up, but for now could anyone please give me a clue on a small issue I've managed to invent!!
On my drawing when I create a simple length dimension but place the dimension and arrows outside the dimension, I have a normal leader from the arrow head to the dimension text, but on the opposite arrow head there is no tail at all, just the arrow head.
So far I've tried adjusting in config:
dim_leader_length
dim_text_gap
leader_elbow_length
set_datum_leader_length
extension_line_offset

I know some of those are unrelated but clutching at straws, so tried all of them to no avail.
Can anybody please point me at whatever stupid thing I'm missing please?
Thanks
 
Replies continue below

Recommended for you

A picture would help.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor