Tolerance display

[Geneg]

Modifying somebody else s drawing...

In Dimension properties, display of Tolerance mode available is NOMINAL only for all the dimensions.

How can I change it and where.

Thanks,

 

[silverado8405]

Drawing properties -> Detail Options -> tol_display should be yes instead of no. That should fix the problem.

 

[duncanmacleod]

I'm trying to set-up and test Creo 3, and I already have config option tol_display set to yes, and I cannot seem to get tolerances to display in the model, or in the drawing, unless I select the dimensions in the model, then set them to display, then they work... Anyone have any ideas?
Thank you.

 

[silverado8405]

Keep doing what you're doing. That's how the tolerances are suppose to work in Creo as not every dimension needs a tolerance automatically put on it.

 

[duncanmacleod]

Had to add option to .dtl file.

Keep doing what you're doing. That's how the tolerances are suppose to work in Creo as not every dimension needs a tolerance automatically put on it.

Had to add "detail_tolerance_mode limits" to the .dtl file.
Now the limit dimensions show up automatically in model and when shown on drawing.
Limit tolerancing is OUR company standard for all dimensions.

Thank you for the post.