Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

revision text

Status
Not open for further replies.

uwam2ie

Automotive
Joined
Jul 11, 2005
Messages
1,008
Location
DE
Hi,
I want to have some advice, the best way to go.
First the requirement, we want to manage revision documentation inside nx 3d parts- in the master.
There are several way to do, fileheader, attribute or expression.
Each option has it's limitation, access from the master model drawing ... , or multi column text, ease of use.
What is the way to go? NX7.5
any tipps are welcome
thanks in advance...
 
I really don't know if this is the best way to go or not, but we do it with attibutes, and then those attributes show up in the revision block. We only show the last two revisions, because we have the option to pull them up off of archive if needed.
 
thank you jerry on reply,
my problem with attributes is a multiline text,
that is part of the question, if there is any other solution,
I don' t know
regards
 
As far as multi-line goes . . .
If you put the attribute in a table cell you can set the overflow options in each cell.
So you may want to consider making your revision box from a table.
I am on NX7.5 too, but I think what I mentioned is easier to do in NX8.5.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top