Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reviewing run-times after analysis

Status
Not open for further replies.
DanJordy

DanJordy

Mechanical
Joined
Jun 14, 2005
Messages
16
Location
US
When I run an analysis, then save and close ANSYS, is there any way to resume that .db/results file to find out how long the analysis ran for?
 
Status
Not open for further replies.

Similar threads

Anurag K
  • Question Question
Hydrostatic bearing CFD analysis
Replies
1
Views
378
karachun
karachun
T
  • Question Question
Accessing Named Selections of Contact Surfaces via CMSEL After Applying Condensed Geometry Not Possible
Replies
0
Views
5K
TOM1345
T
Anatoly_k
  • Locked
  • Question Question
Pipe Burst Pressure - elastic-plastic analysis strange asymmetry
Replies
0
Views
915
Anatoly_k
Anatoly_k
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
801
Rabea-19
R
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top