Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

qualify a welder

Status
Not open for further replies.
bb29510

bb29510

Geotechnical
Joined
Oct 3, 1999
Messages
195
Location
US
Can you qualify a welder on 5/16 steel plate in 1F, In d1.1? All I,m seeing is 3/8. I assume that was a minimum using table 4.11

ICC special inspector, Structural masonry, Reinforced concrete.
 
Sort by date Sort by votes
No, unless you circumvent the requirement by going through the procedure qualification rules (see 4.19.3 in 2010 edition).
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Karik87
  • Locked
  • Question Question
Welder Qualification with AWS A5.14 ERNiCrMo-3 according to AWS D1.1
Replies
2
Views
552
weldstan
weldstan
danggg
  • Locked
  • Question Question
AWS D17.1 WELDER CERT. QUESTION
Replies
2
Views
479
GC_Hopi
GC_Hopi
AAZOMPA
  • Locked
  • Question Question
TO QUALIFY A WELDING PROCEDURE (PQR
Replies
0
Views
318
AAZOMPA
AAZOMPA
nabeel3
  • Locked
  • Question Question
Multiple Electrodes in a WPS
Replies
1
Views
923
gtaw
gtaw
ElronMcK
  • Locked
  • Question Question
AWS D1.2 Welder Qualification TIG
Replies
4
Views
3K
Interpreter888
Interpreter888

Part and Inventory Search

Sponsor

Back
Top