Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pushover analysis

Status
Not open for further replies.
balu25

balu25

Civil/Environmental
Joined
Jun 19, 2007
Messages
30
Location
AT
Hello all,
I want to perform a pushover analysis in ANSYS of a building, with increasing forces for each load step, using the first mode shape, till the building collapses. Any suggestions and advices are welcome.
Thank you
 
Sort by date Sort by votes
Hello,

I think you can just use multi-load steps.
Ansys will give up all the results of every substep.
 
Upvote 0 Downvote
hello Zachary07,
sure i can use multi-load step, but i need the force for which the building collapses. I don't need reactions or so...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Anurag K
  • Question Question
Hydrostatic bearing CFD analysis
Replies
1
Views
381
karachun
karachun
Anatoly_k
  • Locked
  • Question Question
Pipe Burst Pressure - elastic-plastic analysis strange asymmetry
Replies
0
Views
917
Anatoly_k
Anatoly_k
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
802
Rabea-19
R
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
Faraz1997
  • Locked
  • Question Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
1K
NRP99
NRP99

Part and Inventory Search

Sponsor

Back
Top