Pipe feature display

[Perry]

In Pro/E I have used Feature/Create/Solid/Pipe to construct wires in my model. The model looks alright on its own and when placed in an assembly. When I place the assembly into a drawing, a centerline is shown in each of the wires I had constructed. I am unable to find a way to remove these centerlines from my drawing. Does someone have a solution for me?

 

[kshoeman]

create a layer called Pipe (or whatever)

then place the pipe feature you've created on this layer. This will put the pipe centerline on the layer, but not the geometry itself.



good luck.