Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Copy Features Without References

Status
Not open for further replies.

jzecha

Aerospace
Jan 20, 2016
235
US
I am proficient in Catia and Creo and wanted to know if there is a way to copy surfaces, points, or, lines and paste them without a reference?
I know how to do this in Catia, but I can't figure out how to do it in Creo.

Either paste them without references or be able to Isolate them after pasting.
 
Replies continue below

Recommended for you

There is a command to break external references, but don't have the actual command sequence to give.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
You can paste them with reference and when you are done you can "collapse" them. Collapse is a command under model tab, editing, in creo4. However if you have family tables it seems collapse is greyed out.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor