Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to change Pipe segment Diameter? (CREO 4.0)

Status
Not open for further replies.

Fernandoomi

Automotive
Jun 16, 2020
1
BR
I would like to know how can I change the Pipe Diameter from a piping segment.

I made my design not using the "Spec Driven" option.

I tryed going on "Modify", in modify Options marked "Line Stock", then I selected the segment, and finaly on the "Modify Linestock" I changed from the 4 inches to 3 inches as I needed. The problem is that the Ok button is greyed-out. I even tryed to create a new and added a new linestock it stays the same.
Capturar_gd4vi3.png
 
Replies continue below

Recommended for you

Is it possible it is preventing the change because there is no transition that would allow a different diameter?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top