Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PIPE CAP DESIGN

Status
Not open for further replies.
JOHNPIA2

JOHNPIA2

Mechanical
Joined
Nov 9, 2002
Messages
38
Location
CA
With reference to thread 1259-187602, UG-44 is fine but, if you have to check the reinforcement of an opening on a pipe cap, your only choice is to treat the cap as a 2:1 ell. head, no?
 
Sort by date Sort by votes
Yes. Don't forget to apply the thickness tolerance in ASME B16.9
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Amr Shams
  • Locked
  • Question Question
Assistance for Multi-Chamber Vessel Design in COMPRESS
Replies
2
Views
3K
amillsmuel
A
AK8824
  • Locked
  • Question Question
Seismic Design of Columns using NBC 2015
Replies
0
Views
697
AK8824
AK8824
mechengineer
  • Locked
  • Question Question
The governing MAWP to be used in support system and nozzle loads design as well
Replies
0
Views
187
mechengineer
mechengineer
AWDMIKE
  • Locked
  • Question Question
Simple Cylinder with Nozzle Indicating a Zero Design Pressure
Replies
1
Views
273
AWDMIKE
AWDMIKE
JordanB13
  • Locked
  • Question Question
Pipe Length Affecting Design Thickness
Replies
5
Views
370
JordanB13
JordanB13

Part and Inventory Search

Sponsor

Back
Top