Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PIPE CAP DESIGN

Status
Not open for further replies.

JOHNPIA2

Mechanical
Nov 9, 2002
38
With reference to thread 1259-187602, UG-44 is fine but, if you have to check the reinforcement of an opening on a pipe cap, your only choice is to treat the cap as a 2:1 ell. head, no?
 
Replies continue below

Recommended for you

Yes. Don't forget to apply the thickness tolerance in ASME B16.9
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor