Loop thru assembly parts, without update

[kukelyk]

Hi,
I have a journal, what goes thru the assembly, opens each part, extracts a jpg.
How could I switch the model update off?
Thanks in advance

----
kukelyk

 

[Toost]

Model update ?
what update is it you are thinking of ?

Regards,
Tomas

 

[kukelyk]

Hi,
See attached image:
updating features, maybe because of interpart features?


----
kukelyk

 

[cowski]

This is most likely caused by wave links or interpart expressions that need to be updated. You can delay updates (interactively or with code) until later. Loading all the components then doing one large update might be faster than multiple updates during load. The delay update option is usually found in the tools menu (or use the command finder).

www.nxjournaling.com

 

[kukelyk]

So You tell me that there is no way to switch that off?

----
kukelyk

 

[Dave K]

Would setting these ON, in the Customer Defaults help?
"Delay Part Module Update"
"Delay Product Interface Update"
"Delay Geometry, Expressions, and PMI"

-Dave

NX 11, Teamcenter 11