Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

IN-CAVED LOGO on CURVED SURFACE

Status
Not open for further replies.

windcatcher

Industrial
Joined
May 31, 2011
Messages
2
Location
US
I need to build an in-caved logo on a curved surface. I know how to make a raised logo on a curved surface. But how to carve out a 1 mm deep logo on a curved surface, which is created using a loft? The bottom surface of the logo should have the same curvature as the top surface.

I greatly appreciate your help!
 
Or use the Wrap tool with the Deboss (I hate that term) option.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top