IN-CAVED LOGO on CURVED SURFACE

[windcatcher]

I need to build an in-caved logo on a curved surface. I know how to make a raised logo on a curved surface. But how to carve out a 1 mm deep logo on a curved surface, which is created using a loft? The bottom surface of the logo should have the same curvature as the top surface.

I greatly appreciate your help!

 

[ctopher]

Make the logo sketch on a plane above the surface, then extrude-cut toward the surface and use the "offset from surface" selection.

Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion

 

[CorBlimeyLimey]

Or use the Wrap tool with the Deboss (I hate that term) option.

 

[windcatcher]

Thank you so much!