Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

imperfection in geometry

Status
Not open for further replies.
polybog

polybog

Materials
Joined
Jan 24, 2007
Messages
7
Location
US
hi,

i want to force some imperfection in my geometry. actually i have tested one material and that is not isotropic but i am modelling in ansys as isotropic. I came to know that to force anisotropic condition in the material we can change the geometry. is that true? if there is other ways to force anisotropy in the modelling then tell.

polybog
 
Status
Not open for further replies.

Similar threads

T
  • Question Question
Accessing Named Selections of Contact Surfaces via CMSEL After Applying Condensed Geometry Not Possible
Replies
0
Views
5K
TOM1345
T
andradesilva
  • Locked
  • Question Question
problems validating design optimized geometry in ANSYS workbench
Replies
0
Views
237
andradesilva
andradesilva
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
799
Rabea-19
R

Part and Inventory Search

Sponsor

Back
Top