Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

problems validating design optimized geometry in ANSYS workbench

Status
Not open for further replies.
andradesilva

andradesilva

Materials
Joined
Jun 20, 2017
Messages
125
Location
PT
Hi,

I am doing design optimization in ANSYS Workbench 2023 R1. I am getting converged results. However, when I edit the value of the design parameters to the ones that result from the optimization, I get different values from those that are presented in the design explorer module (candidate points). Does anybody know the reasons for this? Which module is correct? Design explorer or Static?

Best regards,
 
Status
Not open for further replies.

Similar threads

struclearner
  • Locked
  • Question Question
Reaction Force Distribution in ANSYS Workbench!
Replies
0
Views
1K
struclearner
struclearner
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
md_salem
  • Locked
  • Question Question
how to do share topology in the design modeler in Ansys Workbench
Replies
1
Views
914
Stick.
Stick.

Part and Inventory Search

Sponsor

Back
Top