IDD surface delete

[kenppy]

How to pick multiple surfaces to delete in IDD?
I recall older versions being able to marquee pick.

 

[kenppy]

OK, got some way in this using surface and seed for quilts [oddly there isn't a quilt filter) but unconnected surfaces still need to be picked one-by-one, a real pain as there are hundreds of tiny shreds.

Does anyone use IDD to clean up imported surfaces?

 

[muadib3d]

I do.

I found it very sh*ty and horrible facing it first time,
but more time I invested to understand the funcionality behind, more I
admire it.

Still, lot of job of cleaning I do outside IDD, in Part Modeling mode.

Hence, with Creo 1.0 and Creo 2.0 extended with Flexible modeling tab these kind of tasks turn to be less complicated.

 

[design-engine]

in the model tree you can select surfaces there.

 

[solidworm]

When i use the command search in IDD, it shows there are a couple of icons for box selection, but ironically they are all disabled

Edit: just found out box selection is enabled only when u select "surface" or "edge" in selection filter. works with non conected surfaces as well. Creo 2.0

 

[mediumsliced]

Just came in to complain about the lack of marquee selection when picking surfaces within IDD too.