Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

I am in the process of designing a 1

Status
Not open for further replies.

ayfarm

Civil/Environmental
Joined
Aug 19, 2002
Messages
42
Location
US
I am in the process of designing a series of air nozzles for the purpose of reducing the interface soil friction/adhesion between a steel plated object and the adjacent undersea dense sand/silt soil strata, N>50<100 approx. This large object is being &quot;sunked&quot; plumb to about 80 ft. depth below the dense &quot;mudline&quot;. Seawater depth is about 110 ft having 3-5k current. Object has four vertical faces, tapered tip and hollow inside. The perimeter air nozzles will operate at about 300 psi working pressure generated by series of air compressors above water. Nozzles must have some kind of pressure/spring activated shut off valves to prevent soil plugs during shut downs. Size, shape, pressure drops, velocity and orientation of the nozzles are important to maximize their &quot;excavating&quot; role during this controlled &quot;sinking&quot;. Commercial availability is a factor. Thanks for any help. Roque Engineers
 
With this sort of design it is quite common to set up a test rig in a Laboratory Tank, because you need some decent data on the soil/mud interface with the nozzle.

It looks like you would need a nozzle, or orifice plate, then an open ended cup to keep the mud out and protect the nozzle. Have a look at your landing forces, and you will have an idea of the size of footprint you need and work back from there.

To control the air you can use a pilot operated shut-off valve, or a solenoid valve.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top