Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to create a tube pattern within a circular plate?

Status
Not open for further replies.

Hallgeir

Petroleum
Apr 15, 2005
1
NO
As a manufacturer of boilers and heat exchangers I am looking for a smart method for generating a hole patter within a circular tube plate. Maybe using iLogic for changing hole diameter, pitch and angel between holes.
The same pattern should also be available in the assembly for component pattern.
Any good ideas?
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor