Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SE2607 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Modifying a Part Description without Up-Revving

Status
Not open for further replies.

MarkCA

Mechanical
Nov 12, 2008
20
I checked an Inventor 2024 part and drawing into Vault and released it only to then realize I'd forgotten to add a Reference Drawing Number in the AES Model Properties.

Is there some way for me to correct this without creating an entirely new revision?

Thanks,
Mark
 
Replies continue below

Recommended for you

If Quick Change is permitted by your administrative settings, that's the solution I'd use. Set your released document revision from Released to Quick Change, make the change, return status to Released.[tt][/tt]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor