Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bend Part Not Working

Thread starter Starker
Start date Apr 3, 2023

Status: Not open for further replies.

Apr 3, 2023

Starker

Mechanical

I need to bend the flaps on a crimp receptacle pin. The conductor flaps (short ones) bent fine, but the insulation flaps (long ones) are throwing errors. The geometry is so simple that I don't know how to make it any easier for Inventor.

Hopefully, somebody will see something that I am not.

File is attached.