Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gap on Surface

  • Thread starter Thread starter amd450
  • Start date Start date
Status
Not open for further replies.
A

amd450

Guest
I did 2 surfaces but there is a gap, I would like of join this two surfaces and I wouldn't like of do a fillet (only join it).



Thanks in advance



Andre Almeida
 
hello



try to use the extend surface feature and then merge>join



hope this helps

xcad
 
Xcad Very Thanks for help me your informations for me was very usefull.



Thanks



Andre Almeida
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top