Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gap on Surface

  • Thread starter Thread starter amd450
  • Start date Start date
Status
Not open for further replies.
A

amd450

Guest
I did 2 surfaces but there is a gap, I would like of join this two surfaces and I wouldn't like of do a fillet (only join it).



Thanks in advance



Andre Almeida
 
hello



try to use the extend surface feature and then merge>join



hope this helps

xcad
 
Xcad Very Thanks for help me your informations for me was very usefull.



Thanks



Andre Almeida
 
Status
Not open for further replies.

Similar threads

dkakth
  • Locked
  • Question Question
dependency on import ?
Replies
1
Views
427
3DDave
3DDave
shanemolloy
  • Locked
  • Question Question
Replacing a component in an assembly based on excel
Replies
0
Views
378
shanemolloy
shanemolloy
7
Achieving a G3 surface condition - Help
Replies
3
Views
4K
ddrichards
D
vorst
  • Locked
  • Question Question
Whats up with Creo's surface selection..?
Replies
10
Views
1K
vorst
vorst
7
G3 surface condition for a nose cone - help
Replies
1
Views
3K
78finn
7

Part and Inventory Search

Sponsor

Back
Top