Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
epdm foaming process
- Thread starter nano67
- Start date
It's a delicate balance, to be sure. I suggest you consult with your EPDM supplier for assistance. Uniroyal used to have a nice tech service center with an extrusion/hot air/microwave line where they'd fine-tune curing and foaming of EPDM compounds. That product line is now owned by Lion Copolymer, and, if you're using their EPDM, I'm sure they could be of assistance.
tom
tom
- Status
Similar threads
- Locked
- Question
- Locked
- Question