Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Circular Jacking Pit

Status
Not open for further replies.
dcarr82775

dcarr82775

Structural
Joined
Jun 1, 2009
Messages
1,045
Location
US
Looking at a circular jacking pit. Intention is to use secant piers. Inside diameter 26-ft, depth 26-ft, 24" shafts, no facing. I am good with all facets of the design except one. The pipe is 10'-6"O.D.. I am having trouble deciding how to model the portion of the compression ring with the hole in it. Anyone have experience in this?

Cheers
 
Status
Not open for further replies.

Similar threads

Nayan67
  • Locked
  • Question Question
How can I model pit using STAAD pro? What is the correct way of computing natural frequency of pit?
Replies
0
Views
287
Nayan67
Nayan67
Alexis7
  • Locked
  • Question Question
FHWA - Circular No4 - Passive resistance calculation (SANDS)
Replies
0
Views
257
Alexis7
Alexis7
HanStrulo
  • Locked
  • Question Question
approach to check circular secant shaft with an unbalanced loading
Replies
3
Views
408
PEinc
PEinc
babibibak
  • Locked
  • Question Question
Jacking Pit Design
2
Replies
39
Views
1K
PEinc
PEinc
hemiv
  • Locked
  • Question Question
Behavior of circular shaft support structure
Replies
8
Views
1K
hemiv
hemiv

Part and Inventory Search

Sponsor

Back
Top