Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cell Library Disappearing! 2

Status
Not open for further replies.

breaks

Structural
Dec 8, 2000
118
US
I've been working on a project that has a certain cell library attached to each MS file. For the last year, the line terminator has worked perfectly. Now, in a few files, when I go to terminate a line using the "Place Active Line Terminator", there is no cell recognized. When I go to "Cells" to check it out, there are NO cells in the library I have attached - it is completely blank. I go into other files and it's working fine. I recreated the LT cell, but this only worked for awhile. I also replaced the cell library on my hard drive with a previously saved version. No dice.

Does anyone have any ideas? Are there settings I'm missing?

Thanks for you help in advance.

p.s. Sorry I couldn't help you with that last question, Rob the Poser - I rarely use that feature!
 
Replies continue below

Recommended for you

Next time you attach a cell library and there are none showing, go to File, and then hit Compress (in the Cell Library box). This should bring them all back.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top