Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bonding of Polyetheretherketone (PEEK) film 1
- Thread starter LiBrown
- Start date
-
1
- #4
patprimmer
New member
Victrex literature says epoxy.
It says cleaned with solvent then dried.
It says surface roughening, flame treatment or etching with chromic acid all improve the bond strength, flame by about 20% and chromic by about 30%.
Epoxy resins give from 0.45 to 5.38mpa bond strength depending on type, surface preparation and method of application.
Hylobond F300 AB 450 CA30 on a solvent cleaned and 80 grit sandblasted surface gave best results.
Regards
Pat
See FAQ731-376 for tips on use of eng-tips by professional engineers &
for site rules
It says cleaned with solvent then dried.
It says surface roughening, flame treatment or etching with chromic acid all improve the bond strength, flame by about 20% and chromic by about 30%.
Epoxy resins give from 0.45 to 5.38mpa bond strength depending on type, surface preparation and method of application.
Hylobond F300 AB 450 CA30 on a solvent cleaned and 80 grit sandblasted surface gave best results.
Regards
Pat
See FAQ731-376 for tips on use of eng-tips by professional engineers &
for site rules
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- News