Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS Worbench Transient Thremal Analysis

Status
Not open for further replies.
snowhouseteam

snowhouseteam

Mechanical
Joined
Feb 19, 2013
Messages
1
Location
US
How do I put convection boundaries without putting any temperature boundaries, when doing a transient thermal analysis in Ansys Workbench?
 
Sort by date Sort by votes
The last time I tried doing a thermal analysis in Workbench (v13), I found it woefully inadequate. I'd recommend trying Ansys APDL (Classic).
 
Upvote 0 Downvote
I believe temperature boundaries are a must because the surrounding temperature matters in convection simulation..

Regards,
Jessi M.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
790
Rabea-19
R
S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
Anurag K
  • Question Question
Hydrostatic bearing CFD analysis
Replies
1
Views
365
karachun
karachun

Part and Inventory Search

Sponsor

Back
Top