Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS fauilre criteria APDL

Status
Not open for further replies.
Ahmedarhman

Ahmedarhman

Structural
Joined
Sep 6, 2014
Messages
10
Location
EG
I'am working with ANSYS 9.00 for modiling concrte girder using solid65. I want to provide a failure criteria to use maximum strain value. and the crosponding results at this value at the postprocess stage. could you please provide an example or information about the procedures.
thank you
regards,
Ahmed
 
Status
Not open for further replies.

Similar threads

rcbsimoes
  • Locked
  • Question Question
ansys apdl, etab, max per row
Replies
1
Views
818
rcbsimoes
rcbsimoes
rcbsimoes
  • Locked
  • Question Question
Shared Faces in Ansys APDL
Replies
0
Views
567
rcbsimoes
rcbsimoes
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
dixdax
  • Locked
  • Question Question
Ansys APDL arrays
Replies
0
Views
515
dixdax
dixdax

Part and Inventory Search

Sponsor

Back
Top