We are currently running two Earthwork 3D's, one on a Numonics Accugrid tablet and one on a Gtco tablet. No problems at all on the Gtco, but we can't use the digitizer on the Numonics board. We reconfigured the digitizer and have the #’s working okay, but we are having a problem with the enter and/or primary click key and the snap key. It is impossible to use the Numonics digitizer at all. Anybody else have that problem or similar problems running a Numonics board with Earthwork 3D? Agtek tech support says they’re not sure and Numonics should be able to help and vise versa.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Agtek Earthwork 3D and Numonics Accugrid Problems
- Thread starter littlesky
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question