Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

BEST CIVIL3D WORKFLOWS FOR SURFACE CREATION AND CUT&FILL ANALYSIS?

Status
Not open for further replies.
E

Emil's Dad

Civil/Environmental
Joined
Dec 10, 2024
Messages
9
hi all - was just wondering if anyone could share their preferred workflows for surface creation and cut& fill analysis in Civil3d? Any other tips on using C3D would be great as well - thanks, Mike
 
Sort by date Sort by votes
The Tutorials that come with the program are a good starting point.
 
Upvote 0 Downvote
yes - they're helpful - was just wondering if anyone had anything else to share - thanks!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S
  • Locked
  • Question Question
Is anybody good at AGTEK software to calculate the cut and fill volume of road project?
Replies
0
Views
2K
Sandeep32
S
Blackfairy
  • Locked
  • Question Question
Pavement Design Question and What to look for Boring logs (California)
Replies
0
Views
2K
Blackfairy
Blackfairy
zahid106
  • Locked
  • Question Question
Earth fill and Compaction under a Septic Leach field
Replies
1
Views
639
TigerGuy
TigerGuy
P
  • Question Question
Ground Screws for Light Structures – Load Performance?
Replies
1
Views
6K
LittleInch
LittleInch
Zack L
  • Locked
  • Question Question
Wall friction and its affect on sheet piles
Replies
2
Views
2K
EireChch
EireChch

Part and Inventory Search

Sponsor

Back
Top