Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Metal and Metallurgy engineering

alek
  • Locked
  • Question Question
Calculate radius and angle for a forming punch for bending sheet metal
Replies
0
Views
154
alek
alek
Ryan9
  • Locked
  • Question Question
Forged 4140 to Simalar Metal
Replies
1
Views
203
tedg
tedg
Vai
  • Locked
  • Question Question
Polishing Alloy with a rough surface
Replies
1
Views
211
Fabrizio
Fabrizio
Dragon
  • Locked
  • Question Question
Replacement for HF in pickling solutions...
Replies
0
Views
110
Dragon
Dragon
hrvat
  • Locked
  • Question Question
Aluminum 6061 T4 for 380 prototype??
Replies
4
Views
295
diamondjim
diamondjim
Vai
  • Locked
  • Question Question
Polishing Alloy with a rough surface
Replies
0
Views
140
Vai
Vai
iamchoyh
  • Locked
  • Question Question
Galvanic Corrosion between A7050 and A2024 and A7075
Replies
0
Views
130
iamchoyh
iamchoyh
carbide
  • Locked
  • Question Question
Magnetic permeability of Cronite HR6 or RA-330 stainless?
Replies
0
Views
123
carbide
carbide
Dragon
  • Locked
  • Question Question
Good cleaner for metal tubes?
Replies
0
Views
146
Dragon
Dragon
?
  • Locked
  • Question Question
Failure Analysis and Prevention
Replies
2
Views
211
arunmrao
arunmrao
Martyn
  • Locked
  • Question Question
Welding 3CR12 Ferritic Stainless Steel
Replies
0
Views
122
Martyn
Martyn
slick
  • Locked
  • Question Question
carbon steel
Replies
0
Views
150
slick
slick
raspoutin
  • Locked
  • Question Question
zincum
Replies
1
Views
180
neil71
neil71
Dragon
  • Locked
  • Question Question
Problems with metal stains, etc.
Replies
2
Views
231
Dragon
Dragon
?
  • Locked
  • Question Question
CV18W Material
Replies
0
Views
245
-
?
eureka
  • Locked
  • Question Question
Material Identification
Replies
1
Views
150
Consulting
Consulting
kapellah
  • Locked
  • Question Question
calculating required length of tube needed for cutting
Replies
0
Views
120
kapellah
kapellah
warburton1
  • Locked
  • Question Question
Relative cost of Aluminum Grades
Replies
0
Views
138
warburton1
warburton1
newguy
  • Locked
  • Question Question
type 409 versus type 321 for Ht. Exchanger Application
Replies
1
Views
164
arunmrao
arunmrao
?
  • Locked
  • Question Question
Magnetic Stainless Steel?
Replies
1
Views
185
arunmrao
arunmrao
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top