Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

MadMango
  • Locked
  • Question Question
Inspection Dimensions
Replies
5
Views
2K
KENAT
KENAT
caseynick
  • Locked
  • Question Question
next Y14.5
Replies
5
Views
163
MechNorth
MechNorth
rltw
  • Locked
  • Question Question
Calling out Material Condition, ie: Hardness
Replies
10
Views
950
CoryPad
CoryPad
josewong
  • Locked
  • Question Question
TYPICAL or TYP notation on drawings
2 3
Replies
57
Views
8K
fcsuper
fcsuper
KENAT
  • Locked
  • Question Question
lower case in drawing title/notes
Replies
4
Views
457
KENAT
KENAT
TimSr
  • Locked
  • Question Question
Ballons on Assembly drawings
2
Replies
24
Views
2K
KENAT
KENAT
metL4mr
  • Locked
  • Question Question
Surface Finish marks
Replies
10
Views
431
KENAT
KENAT
Tetragrammaton
  • Locked
  • Question Question
2 Column Assembly Stack calculations - can anyone help?
Replies
6
Views
288
TomGDandT
TomGDandT
USAYES
  • Locked
  • Question Question
GD&T Symbols for MS/Word
Replies
4
Views
1K
TomGDandT
TomGDandT
Luisen
  • Locked
  • Question Question
Tolerance Profile Surface or Profile Line
Replies
13
Views
770
TomGDandT
TomGDandT
boottmills
  • Locked
  • Question Question
Drafting Stadards Manual
Replies
15
Views
562
Tunalover
Tunalover
screaminjimmy
  • Locked
  • Question Question
Nomenclature for structural steel shapes
Replies
3
Views
680
CheckerRon
CheckerRon
LONDONDERRY
  • Locked
  • Question Question
What should appear on a drawing parts list?
2
Replies
21
Views
2K
ctopher
ctopher
Creech
  • Locked
  • Question Question
Assumed Straigtness or Flatness
Replies
18
Views
471
Creech
Creech
ARamsay
  • Locked
  • Question Question
Standard Metric sizes for bar stock and piping
Replies
1
Views
161
ctopher
ctopher
JamesDWeed
  • Locked
  • Question Question
Positional Tolerance Zones (square vs. round)
Replies
11
Views
1K
drawoh
drawoh
gmarken
  • Locked
  • Question Question
Spec Control Drawings
Replies
10
Views
590
MikeHalloran
MikeHalloran
Randy1111
  • Locked
  • Question Question
Measuring GD&T
Replies
8
Views
362
Tunalover
Tunalover
LONDONDERRY
  • Locked
  • Question Question
parts list debate
Replies
15
Views
432
KENAT
KENAT
PTMALM
  • Locked
  • Question Question
Model vs Drawing tolerances (Y14.41 ?) & notes.
Replies
16
Views
910
KENAT
KENAT
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top